Shell Programming Blog Shell Programming Blog

Sunday 2 September 2012

how to configure Your BIOS for Faster Startups

Unknown | 17:46 |



You can speed up your startup procedures by changing the BIOS with the built-in setup utility. How you run this utility varies from PC to PC, but you typically get to it by pressing the Delete, F1, or F10 keys during startup. You'll come to a menu with a variety of choices. Here are the choices to make for faster system startups:

Quick Power On Self Test (POST)
When you choose this option, your system runs an abbreviated POST rather than the normal, lengthy one.

Boot Up Floppy Seek
Disable this option. When it's enabled, your system spends a few extra seconds looking for your floppy drives relatively pointless procedure, especially considering how infrequently you use your floppy drive.

Boot Delay
Some systems let you delay booting after you turn on your PC so that your hard drive gets a chance to start spinning before bootup. Most likely, you don't need to have this boot delay, so turn it off. If you run into problems, however, you can turn it back on.

0 Comments:

   

Post a Comment

Don't just read and walk away, Your Feedback Is Always Appreciated. I will try to reply to your queries as soon as time allows.

Note:
1. If your question is unrelated to this article, please use our Facebook Page.
2. Please always make use of your name in the comment box instead of anonymous so that i can respond to you through your name and don't make use of Names such as "Admin" or "ADMIN" if you want your Comment to be published.
3. Please do not spam, spam comments will be deleted immediately upon my review.

Regards,
Mohamed Abubakar Sittik A

 

Shell Programming Copyright © 2012 Shell Programming theme is Designed by Abusittik, Shell Programming